B&G HS2000 - Manual (Page 20)

HS 2000 User Manual
Part 2 - Operating Information
HB-0846-03
2-7
selected for display on any of the FFDs or the Halcyon Display. In
addition analogue compass card type displays may be added.
Note
Analogue displays require an additional Wind Board (402-10-005) to
be installed in the processor box.
Software incorporated with the compass allows the compass to learn
the magnetic fields in the vessel which may cause deviation errors.
These errors can be reduced to an insignificant level by following the
Calibration procedure described in Part 3.
2.4 EXAMPLES OF OPERATION
The general principle of operating the HS 2000 System will be made
clear by the following examples of function and page selection, and
damping.
2.4.1 Function Selection
Our first example will be to select another function for one of the
displays. The new function is Stored Log which we want to place in
the lower display.
(1) Select the lower display by pressing the Scroll Down
Key. The lower display will start to flash. The upper display
is not affected.
(2) Using the Scroll Up and/or Scroll Down Keys, scroll
through the menu until the required menu (LOG) is shown
flashing in the lower display. The upper display is not
affected.
(3) Press the Enter Key, the lower display now shows the
STD LOG flashing, the upper display is not affected.
Note
If another menu choice is required (for example, Trip Log), scroll
through the menu choices using the Scroll Up/Scroll Down Keys
until the required choice is displayed in the lower display.
(4) Press Enter again, the lower display now shows
required function, the upper display is not affected.
At this stage we have simply called up this function for viewing, if the
Page Key is pressed, then the configured page will return and Stored
Log will no longer be displayed. If, however, you wish to keep Stored
Log on a page, then you can configure the page.