B&G HS2000 - Manual (Page 71)

HS 2000 User Manual
Part 5 - Options
HB-0846-03
5-8
(3) Press the Scroll Down key until the display shows
POWER BOAT.
(4) Press the Page key to exit the setup mode.
The Halcyon Display has now been configured for Cruise Power
operation.
5.4.5
Off Course Function
The Off Course function provides the helmsman with accurate Off
Course information to assist in steering a steady and accurate
course.
Off Course is calculated by comparing the vessel’s current
heading with a previously set reference heading. The deviation is
shown by the bar graph and numerically as degrees port or
starboard.
The bar graph scale shows one segment for every 2
? off course up
to 10 ? , then one segment for every 5 ? up 20 ? . If the current
heading is the same as the desired heading then only the central
segment will be shown. The numeric display will show 00.
The Off Course function may be reset by pressing the Enter Key,
operation of a Remote Push-button if fitted or from any FFD.
Pressing the Enter Key or Remote Push-button will select the
current heading as the reference heading.
Any deviation from this new course will be shown on the bar graph
and the numerical display. To reset the off course function from an
FFD, select the NAVIGATE Menu and then OFF CRSE as
described in Part 2 - Operating Information.
5.4.6
Stored Course Function
Up to 10 preset courses, numbered CRS 1 to CRS 10, may be
stored at any one time. When the Stored Course function is
selected by operation of the Page Key the display changes to
show the selected course number with the value immediately
below. All courses are retained in the Halcyon Display memory
during power off so that the desired courses may be entered prior
to departure.