B&G HS2000 - Manual (Page 78)

HS 2000 User Manual
Part 6 - Diagnostic Data
HB-0846-03
6-5
6.1.8 Lighting
This option checks for correct operation of the display lighting
control.
6.1.9 Debug
CAUTION: This test is not for normal use, since it may
seriously affect the operation of the HS 2000 System.
This option is used for accessing memory in other units in the
system.
6.1.10 RES-SYS
CAUTION: Do not use this option during normal operation as
the system will give inaccurate results until re-calibrated.
This option allows either individual units or the entire system to be
reset. The network node address of the unit to be reset is selected
using the Scroll Up and Scroll Down Keys and then pressing
Enter. The node allocations are as follows:
01 - Depth Board 05 - Wind Board
09 - NMEA Interface 0D - Expansion Board
FF - Entire System
Note
FFD software prior to 3B is unable to reset individual units. When
the system is reset, all calibration, damping and alarm values will
return to default settings and all log values and trip functions will
reset to zero, all display units will reset to the default page
settings. After a delay of approximately 20 seconds the system
should be switched OFF and then ON, twice, to complete the reset
procedure. This is necessary as some of the units are
automatically re-configured depending on which other units are
connected to the network.
6.1.11 Versions
This option allows the user to ascertain the software version
numbers for the FFD (DISPLAY) and Depth Sounder (DEPTH).
When VERSIONS is displayed flashing on the screen, press
Enter, use the Scroll Up Key to select the required version
number. Press Enter to display the software checksum of the
appropriate unit in the lower display. The two least significant
digits of the checksum indicate the software version number.