B&G HS2000 - Manual (Page 72)

HS 2000 User Manual
Part 5 - Options
HB-0846-03
5-9
To select a specific course number proceed as follows:
(1) Select the Stored Course Function by successive
presses of the Page Key until the display shows the
Stored Course Function.
(2) Press Scroll Up and CRS 1 will flash.
(3) Using the Scroll Up and/or Scroll Down Keys select
the course (CRS) number required.
(4) Press the Enter Key to enter the selected course as
the reference.
To change the value of any stored course proceed as follows:
(1) Select the Stored Course Function by successive
presses of the Page Key until the display changes to
show the Stored Course Function.
(2) Press the Scroll Down Key and the stored value of
the course selected will flash.
(3) Using the Scroll Up and Scroll Down Keys change
the value to the new course.
(4) Press the Enter Key to enter the new course.
5.4.7 Turn Rate Function
The turn rate function displays the vessel’s rate of turn in degrees
to port or starboard. There are two ways of displaying this, either
as a mean rate of turn or as an instantaneous rate of turn in
degrees per second.
5.4.8 Mean Rate
Whenever the turn rate function is selected using the PAGE key,
the mean rate of turn is displayed. The MEAN legend is shown on
the display.
The present heading is compared with a continually updated
heading and displayed graphically and numerically as degrees to
port or starboard. This will give a trend to the right or left of the
average heading. Hence, if the heading fluctuates both to port and
starboard, but with a bias to port, then a net trend to port will be
displayed. Similarly for a starboard trend.