B&G HS2000 - Manual (Page 27)

HS 2000 User Manual
Part 2 - Operating Information
HB-0846-03
2-14
(2) Press Scroll Down once and the lower text now
shows CONTROL flashing.
(3) Press Enter and use the Scroll Down key to display
RESET flashing.
(4) Press the Enter key and the display now shows RUN
flashing.
(5) Press the Enter key again and the display shows the
trip log running.
(6) Press the Page key to resume normal operation.
Note
Each time you reset the TRIP LOG the AVERAGE SPEED resets
and begins its calculation again. The control facility for the Dead
Reckoned functions works in the same way; the bearing and
distance are linked so that they start simultaneously.
2.8 LIGHTING CONTROL
The level of illumination at system displays is controlled by the
Power/Light Key. Use of this key normally controls all the HS 2000
System displays simultaneously. However, the level of illumination on
a single FFD can be controlled individually using the menu choice -
LOCAL LIGHTING.
2.8.1 Select Local Control
(1) Press and hold Scroll Up or Scroll Down until
LIGHTING appears in the text.
(2) Press Enter.
(3) Press Scroll Up until LOCAL is displayed.
(4) Press Enter again, the original page display appears.
Control of the FFD is now in local mode.
Successive operation of the On/Off Illumination Key now controls
the current display only. This will enable you to use very low lighting
at the chart table while maintaining the brightness up on deck.
2.8.2 Select System Control
(1) Press and hold Scroll Up or Scroll Down until
LIGHTING is displayed in the text.
(2) Press Enter and Scroll Up or Scroll Down to select
SYSTEM.