B&G HS2000 - Manual (Page 42)

HS 2000 User Manual
Part 3 - Calibration
HB-0846-03
3-6
3.2.6 Manual Calibration
The calibration values can be adjusted directly as shown in
‘Examples of Calibration’ included in Part 2 - Operating
Information.
3.2.7 Speed Calibration Referenced to a Known Value
The following enhancement is only available when HS 2000
speed/depth computer is used in conjunction with an HS 2000
FFD Display with a software version later than 5C.
To calibrate the boat speed with reference to a known value, for
instance, another boat with an accurately calibrated log, proceed
as follows:
Select BOAT SPD KT on the upper half of the FFD display.
(1) Press Scroll Down until the lower text shows
CALBRATE flashing.
(2) Press Enter, the lower text now shows AUTO CAL
flashing.
(3) Press Scroll Down until the lower text shows REF
CAL flashing.
(4) Press Enter, the lower text now shows REF CAL
together with the current boat speed.
(5) Press Enter, the lower text now shows REF CAL
flashing and by use of the Scroll Up/Down the reference
speed may be adjusted.
(6) Press Enter, the new speed value is accepted and
the upper display will show the re-calibrated boat speed.
3.2.8 Boat Speed Calibration (Knots, MPH, KPH)
To select the required boat speed units proceed as follows:
(1) Press Scroll Up until the upper text shows LOG
flashing.
(2) Press Enter, the upper text now shows STD LOG
flashing.
(3) Press Scroll Up until the upper text shows TRIP
LOG flashing.
(4) Press Enter until the upper text shows TRIP LOG
and the current value.
(5) Press Scroll Down, until the lower text shows
CALBRATE flashing.