Dell PowerVault 136T LTO/SDLT (Tape Library) - Manual (Page 77)

Contact Dell Customer Support .
46 xx
The barcode scanner detected a cartridge when one was not expected. This occurs because the magazine's fiducial
label was not scanned by the library. Therefore, the library does not recognize the magazine as being installed in the
column.
This problem is caused by a magazine fiducial label that is too reflective for the Barcode scanner to read. Cover the fiducial label
with a piece of translucent scotch tape to correct this problem.
Check for a dirty, damaged, missing or wrong fiducial label on the magazine containing the cartridge in question.
Contact Dell Customer Support .
60 xx
Cannot complete the Lock/Unlock Mailbox commands.
Run Lock Diagnostics from the Operator panel to see if there are any mechanical bindings. See Sensor Dialog .
Contact Dell Customer Support .
70 xx
Failures detected in the Picker Assembly Grip Finger Open operation.
Run Grip finger diagnostics. See Picker Submenu .
Contact Dell Customer Support .
71 xx
Failures detected in the Picker Assembly Grip Finger Close operation.
Run Grip finger diagnostics. See Picker Submenu .
Contact Dell Customer Support .
72 xx
A Get command was issued but the sensor indicated that a cartridge is already present in the Picker Assembly.
Look into the Picker Assembly and see if a cartridge is present. If a cartridge is found in the picker, recover the cartridge and place
it in any empty slot, close the door and retry the failing operation.
73 xx
Failures detected in the Picker Assembly Finger Open/Close operations.
Contact Dell Customer Support .
74 xx
A Get command was issued but the sensor indicated that the source location is empty.
This error can be caused by a cartridge that is not fully inserted in the storage slot above the failing slot. If this condition exists, push
the cartridge into its slot and close the library door.
Contact Dell Customer Support .
77 xx
Failures detected in the Picker Assembly during a Retract operation.
Contact Dell Customer Support .
78 xx
A Put command was issued but the sensor indicated that the cartridge is not present in the Picker Assembly.
Contact Dell Customer Support .
7A xx
Failures detected in the Picker Assembly Reach/Retract operations.
Contact Dell Customer Support .
7C xx
Failures detected in the Picker Assembly Reach operation.
Check for obstruction in the slot. Obstruction can be in the form of:
l an unlabeled cartridge.
l
a cartridge in the slot during a Put operation.
l the slot wall in the magazine is too tight.
l
a tape drive failure which prevents the cartridge from being inserted properly.
Remove the obstruction or replace the magazine, close the door and retry the failing operation.
Contact Dell Customer Support .
7E xx
Failure detected while pushing a cartridge into a Tape drive feed slot.
Check the cartridge for any physical damage.
Replace the failing Drive Module.
80 xx
Failures detected in the Rotary-axis Servo system.
Contact Dell Customer Support .
81 xx
Failures detected in the Y-axis Servo system.
Contact Dell Customer Support .
82 xx
An unexpected Motion Control condition was received.
Contact Dell Customer Support .