Dynojet 424 Linx: DWRT Installation Guide User Manual
Dynojet Equipment
Advertising
Table of contents
Document Outline
- Cover
- Copyright
- Table of Contents
- 424 Linx Installation
- Introduction
- Linx Belt Drive Specifications
- Unpacking the Linx Parts
- Dynojet Logo Panels and Pit Covers
- Inner Mounting Plate Installation
- Flange Bearing, Outer Shaft, and Splined Shaft Installation
- Drive Pulley Installation
- Idler Pulley Assembly Installation
- Belt and Tensioner Pulley Assembly Installation
- Pulley Mounting Plates and Outer Bearings Installation
- Installing the Idler Pulley Outer Bearing, Bearing Mounting Plate, and Lower Pulley Mount
- Installing the Moveable Dyno Pulley Outer Bearing, Bearing Mounting Plate, and Lower Pulley Mount
- Installing the Upper Moveable Dyno and Idler Pulley Mounts
- Installing the Stationary Dyno Pulley Outer Bearing, Bearing Mounting Plate, and Lower Pulley Mount
- Installing the Upper Stationary Dyno Pulley Mount
- Brake Signal Relay Installation
- Tension the Belt
- Above Ground Covers
- In Ground Covers
- Disconnect the Belt Drive from the Dyno Drums
- A - Red Head Anchor Installation
- B - Disconnect the Belt Drive from the Dyno Drums—Early Version Shafts
- C - Shaft Safety Wire Installation