Inner mounting plate installation, Installing the inner mounting plate—moveable dyno – Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 14
Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Inner Mounting Plate Installation
10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INNER MOUNTING PLATE INSTALLATION
Use the following instructions to install the moveable dyno and stationary dyno inner
mounting plates.
You will need the following parts:
• 36582471
Bolt, 3/8-16 x 1.5", Flange-Hex (2)
• 36923100
Washer, 3/8", Flat (18)
• 61300024
Inner Mounting Plate, Stationary Dyno
• 61300027
Inner Mounting Plate, Moveable Dyno
• DM150-011-004
Nut, 3/8-16, Hex (2)
• DM150-019-012
Bolt, 3/8-16 x 1", Hex (16)
I
NSTALLING
THE
I
NNER
M
OUNTING
P
LATE
—M
OVEABLE
D
YNO
1
Secure the inner mounting plate to the moveable dyno using eight 3/8 x 1-inch
bolts and eight 3/8-inch flat washers.
Note: For above ground installations, use only six 3/8 x 1-inch bolts and
six 3/8-inch flat washers.
Figure 5: Secure the Inner Mounting Plate to the Moveable Dyno
XD006
for in ground
installations only
inner mounting plate