Dynojet 424 Linx: DWRT Installation Guide - Manual (Page 56)

Linx Installation for Model 424 Automotive Dynamometers
A P P E N D I X C
Installation
C-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
Use the following instructions to install the shaft safety wire.
Failure to secure the cap screws with safety wire can result in damage to the
dyno and/or the vehicle.
1 Torque the cap screws to 7 ft.-lb. (9.5Nm).
2 Bend the wire into a U shape with equal ends.
3 Insert the wire through the hole in the bolt.
4 Loop one end of the wire around the bolt clock-wise and match up the ends of
the wire.
5 Using safety wire pliers, clamp the ends of the wire together and twist the wires
together until you reach the second bolt.
6 Remove the safety wire pliers.
7 Insert the wire through the hole in the second bolt.
8 Loop one end of the wire around the bolt counter clock-wise and match up the
ends of the wire.
9 Using safety wire pliers, clamp the ends of the wire together and twist the wires
together.
10 Cut off the excess wire.
11 Tuck the remaining wire around the bolt.
Figure C-1: install the Shaft Safety Wire
4
3
9, 11
5
7
8