Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 12
Advertising
Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Dynojet Logo Panels and Pit Covers
8
3
Remove the two 7/16-14 x 1-inch hex bolts, two 7/16-inch flat washers, and two
7/16-14 nuts securing the lower mounting bracket to the dyno. Set the hardware
aside.
4
Remove the lower mounting bracket and set aside.
5
Remove the two 3/8-16 x 3/4-inch hex bolts and two 3/8-inch flat washers securing
each mounting bracket to the dyno. Set the hardware aside.
6
Remove each mounting bracket and set aside.
Figure 3: Remove the Logo Panel Mounting Brackets
XD002
XD003
mounting bracket
lower mounting bracket
Advertising