Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 27
Advertising
4 2 4 L I N X I N S T A L L A T I O N
Pulley Mounting Plates and Outer Bearings Installation
Version 6
Linx Installation for Model 424 Automotive Dynamometers
23
I
NSTALLING
THE
U
PPER
M
OVEABLE
D
YNO
AND
I
DLER
P
ULLEY
M
OUNTS
1
Place a lower stationary dyno pulley mount (P/N 61300023) over the moveable
dyno pulley and loosely secure the mount to the inner plate using
five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers (one of the holes in the
pulley mount is not used).
2
Loosely secure the pulley mount to the moveable dyno pulley bearing plate using
five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.
Figure 20: Secure the Pulley Mount Over the Moveable Dyno Pulley
XD059
pulley mount
P/N 61300023
Advertising