Above ground covers – Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 37
4 2 4 L I N X I N S T A L L A T I O N
Above Ground Covers
Version 6
Linx Installation for Model 424 Automotive Dynamometers
33
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ABOVE GROUND COVERS
You will need the following parts:
• 21200095
Belt Cover, End Panel (2)
• 21200097
Belt Cover, Top (2)
• 21400006
Belt Cover, Leg (8)
• 21600026
Belt Cover, Center Support
• 36561045
Screw, 1/4-20 x 5/8", Pan-Head, Torx (64)
• 61100013
Belt Cover, Front Panel Assembly (2)
• DM150-020-005
Nut-Crush, 1/4-20 (8)
1
Place the tops flange side up on the floor.
2
Secure two legs in the corners of each top as shown using four 1/4-20 x 5/8-inch
torx screws each.
3
Secure one leg in the middle of each top as shown using two 1/4-20 x 5/8-inch
torx screws each.
4
Secure one leg in the corner of each top as shown using two 1/4-20 x 5/8-inch torx
screws each.
5
Secure each end panel using six 1/4-20 x 5/8-inch torx screws.
Figure 29: Install the Legs and End Panels
XD090
end panel