Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 44
Advertising
Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
In Ground Covers
40
6
Secure the six angle feet to the pit cover assemblies in the positions shown using
one 3/8-16 x 1/2-inch button-head flange bolt each.
7
Using the feet as a template, drill each hole needed to secure the feet to the floor.
8
Install the six Red Head anchors. Refer to Appendix A for installation instructions.
9
Secure each foot to the floor using one 3/8-16 x 1-inch hex bolt and one 3/8-inch
washer.
10 Secure one access cover to each pit cover assembly using six 1/4-20 x 5/8-inch torx
screws each.
Figure 36: Install the Pit Cover Feet and Access Covers
XD037
access cover
Advertising