Removing the pit covers—in ground – Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 13
Advertising
4 2 4 L I N X I N S T A L L A T I O N
Dynojet Logo Panels and Pit Covers
Version 6
Linx Installation for Model 424 Automotive Dynamometers
9
7
Remove the two 3/8-16 x 1.5-inch flange hex bolts, washers, and nuts securing the
rear deck brace to the mounting bracket. Set the hardware aside.
8
Remove two 3/8-16 x 1.5-inch flange hex bolts securing the rear deck brace
mounting bracket to the dyno. Set the hardware aside.
9
Remove the rear deck brace mounting bracket and set aside.
Figure 4: Remove the Rear Deck Brace Mounting Bracket
R
EMOVING
THE
P
IT
C
OVERS
—I
N
G
ROUND
If present, remove any pit covers on this side of the dyno.
XD004
XD005
rear deck brace
mounting bracket
rear deck brace
Advertising