Dynojet 424 Linx: DWRT Installation Guide - Manual (Page 6)

Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Introduction
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INTRODUCTION
Thank you for your interest Dynojet’s Automotive Dynamometers. Before installing
the Linx system, please take a moment to read this guide for proper installation
procedures.
Note: The Linx system is for 88-130-inch wheel base dynos only and cannot be
used with the extension kit.
C ONVENTIONS U SED I N T HIS M ANUAL
The conventions used in this manual are designed to protect both the user and the
equipment.
D RILL AND D RILL B IT R EQUIREMENTS
You will need to provide a drill and drill bit capable of drilling holes in concrete. Refer
to Appendix A for more information on installing Red Head Anchors.
• drill bit size: 1/2-inch
• minimum hole depth: 1 5/8-inch (41.2 mm)
T ECHNICAL S UPPORT
For assistance, please contact Dynojet Technical Support at 1-800-992-3525, e-mail
Dynojet at [email protected], or write to Dynojet at 2191 Mendenhall Drive,
North Las Vegas, NV 89081.
Visit us on the World Wide Web at www.dynojet.com where Dynojet provides state of
the art technical support, on-line shopping, 3D visualizations, and press releases
about our latest product lines.
example of convention description
The Caution icon indicates a potential hazard to the
dynamometer equipment. Follow all procedures
exactly as they are described and use care when
performing all procedures.
The Warning icon indicates potential harm to the
person performing a procedure and/or the
dynamometer equipment.