Drive pulley installation – Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 19
4 2 4 L I N X I N S T A L L A T I O N
Drive Pulley Installation
Version 6
Linx Installation for Model 424 Automotive Dynamometers
15
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DRIVE PULLEY INSTALLATION
Use the following instructions to install the drive pulleys for both the moveable and
stationary dynos.
You will need the following parts:
• 32300002
Bushing (2)
includes three bolts and lock washers each
• 32300003
Grooved Pulley (2)
1
Place the bushing into the grooved pulley.
Figure 11: Align the Bushing in the Grooved Pulley
2
Loosely secure the bushing in the pulley using the three included bolts and lock
washers.
3
Slide the pulley assembly onto the outer shaft.
Figure 12: Install the Moveable Dyno Pulley Assembly
grooved pulley
bushing
section view of bushing
and grooved pulley to
show correct alignment
with the tapered hole
XD051
bushing
grooved pulley