Dynojet 424 Linx: DWRT Installation Guide - Manual (Page 11)

4 2 4 L I N X I N S T A L L A T I O N
Dynojet Logo Panels and Pit Covers
Version 6 Linx Installation for Model 424 Automotive Dynamometers
7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNOJET LOGO PANELS AND PIT COVERS
The Linx option can only be installed on one side of the dyno, refer to Figure 1. When
the Linx option is being installed on an existing above ground dyno, the Dynojet logo
panels must be removed. When the Linx option is being installed on an existing in
ground dyno, the pit covers must be removed.
If your Dynojet logo panels or pit covers are already removed, continue with “Inner
Mounting Plate Installation” on page 10.
R EMOVING THE D YNOJET L OGO P ANELS —A BOVE G ROUND
Repeat the following steps for each logo panel.
1
Remove the five 1/4-20 x 5/8-inch pan-head torx screws securing the logo panel to
the mounting brackets. Set these screws aside.
2 Remove the logo panel and set aside.
Figure 2: Remove the Dynojet Logo Panel
XD001
logo panel