Reconnecting the belt drive – Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 46
Advertising
Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Disconnect the Belt Drive from the Dyno Drums
42
R
ECONNECTING
THE
B
ELT
D
RIVE
1
Remove the 1/4-20 x 1.25-inch cap screws from the threaded holes in the splined
shaft.
2
Slide the shaft into the dyno drum aligning the two unthreaded holes in the
splined shaft flange with the two threaded holes in the outer shaft.
3
Install the 1/4-20 x 1.75-inch cap screws and 1/4-inch lock washers and torque to
7 ft.-lb. (9.5Nm).
4
Secure the cap screws with the shaft safety wire. Refer to Appendix C for
installation instructions.
Failure to secure the cap screws with safety wire can result in damage to the
dyno and/or the vehicle
Advertising