Installing the upper stationary dyno pulley mount – Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 31
4 2 4 L I N X I N S T A L L A T I O N
Pulley Mounting Plates and Outer Bearings Installation
Version 6
Linx Installation for Model 424 Automotive Dynamometers
27
I
NSTALLING
THE
U
PPER
S
TATIONARY
D
YNO
P
ULLEY
M
OUNT
1
Place the upper stationary dyno pulley mount (P/N 61300022) over the stationary
dyno pulley and loosely secure the mount to the inner plate using
five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers (one of the holes on the
pulley mount is not used).
2
Loosely secure the pulley mount to the stationary dyno pulley bearing plate using
five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.
3
While applying upward pressure to support the shaft and pulley, tighten all the
bolts.
Figure 25: Secure the Pulley Mount Over the Stationary Dyno Pulley
XD063
pulley mount
P/N 61300022