In ground covers – Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 41
4 2 4 L I N X I N S T A L L A T I O N
In Ground Covers
Version 6
Linx Installation for Model 424 Automotive Dynamometers
37
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IN GROUND COVERS
You will need the following parts:
• 21200098
Pit Cover Mount
• 21217513
Calibration Access Cover (2)
• 21600026
Belt Cover, Center Support
• 21919101
Feet, Pit Cover (6)
• 36561045
Screw, 1/4-20 x 5/8", Pan-Head, Torx (16)
• 36580434
Bolt, 3/8-16 x 1/2" Button-Head Flange, Allen (8)
• 36923100
Washer, 3/8", Flat (6)
• 37513200
Anchor, Red Head, 3/8" (6)
• 37518200
Red Head Anchor Installation Tool
• 61329400
Pit Retarder Cover Assembly (2)
• DM150-019-012
Bolt, 3/8-16 x 1", Hex (6)
• DM150-020-005
Nut-Crush, 1/4-20 (4)
1
Secure the center support to the pit cover mount using four 1/4-20 x 5/8-inch torx
screws and four 1/4-20 nuts.
Note: When the dyno is equipped with the wheelbase extension kit
(P/N 61119183), use the center support (P/N 21200176) included in the kit.
Figure 33: Secure the Center Support to the Pit Cover Mount
pit cover mount
center support
pit cover mount
center support
center support included with
wheelbase extension kit