Dynojet 424 Linx: DWRT Installation Guide - Manual (Page 38)

Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Above Ground Covers
34
6 Secure the two tops together using two 1/4-20 x 5/8-inch torx screws and two
1/4-20 nuts each.
7 Secure the center support to the tops using four 1/4-20 x 5/8-inch torx screws and
four 1/4-20 nuts.
Note: When the dyno is equipped with the wheelbase extension kit
(P/N 61119183), use the center support (P/N 21200176) included in the kit.
Figure 30: Secure the Tops Together and Install the Center Support
XD091
center support
center support included with
wheelbase extension kit