Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 26
Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Pulley Mounting Plates and Outer Bearings Installation
22
I
NSTALLING
THE
M
OVEABLE
D
YNO
P
ULLEY
O
UTER
B
EARING
, B
EARING
M
OUNTING
P
LATE
,
AND
L
OWER
P
ULLEY
M
OUNT
1
Secure the outer moveable dyno pulley bearing to the moveable dyno pulley
bearing plate using four 9/16-12 x 2-inch bolts, four 9/16-inch flat washers, and
four 9/16-inch nuts. Slide this assembly onto the moveable dyno pulley outer
shaft.
Figure 18: Install the Outer Moveable Dyno Pulley Bearing and Bearing Plate
2
Place the lower moveable dyno pulley mount (P/N 61300026) under the
moveable dyno pulley and loosely secure the mount to the inner plate using
five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.
3
Loosely secure the pulley mount to the moveable dyno pulley bearing plate using
three 3/8-16 x 1-inch bolts and three 3/8-inch flat washers.
Figure 19: Secure the Pulley Mount Under the Moveable Dyno Pulley
XD057
moveable dyno
puller bearing
moveable dyno pulley
bearing plate
moveable dyno
pulley
XD058
pulley mount
P/N 61300026