See level 4 submenu descriptions in table – Rice Lake 820i Programmable Indicator/Controller - Installation Manual User Manual

Page 33

Advertising
background image

Configuration

29

Figure 3-7. SCALES Menu, CALIBR Submenu

See the

iQUBE

Installation Manual, PN 77224, for information about configuring

iQUBE

scales.

Table 3-5. SCALES Menu, CALIBR Submenu Parameters

SCALES Menu, CALIBR Submenu

Parameter

Choices

Description

Level 4, CALIBR submenu

WZERO

Press ENTER to display and edit the zero calibration A/D count or millivolts value.

WVAL

Press ENTER to display and edit the test weight value.

WSPAN

Press ENTER to display and edit the span calibration A/D count or millivolts value.

WLIN

POINT 1 —
POINT 5

Press ENTER to display and edit test weight and calibration values for up to five linearization points.

Perform linear calibration only after WZERO and WSPAN have been set.

REZERO

Press ENTER to remove an offset value from the zero and span calibrations.

Note

Use this parameter only after WZERO and WSPAN have been set. See Section

4.2 on

page

48 for more information about using this parameter.

UNITS

lb
kg
g
oz
tn
t
gn
troyoz
troylb
lt
CUSTOM
NONE
OFF

Specifies primary units for displayed and printed weight. Values are: lb=pound; kg=kilogram;
g=gram; oz=ounce; tn=short ton; t=metric ton; gn=grain; troyoz=troy ounce; troylb=troy
pound; lt=long ton.

WZERO

WVAL

WSPAN

WLIN

REZERO

POINT 4

POINT 5

POINT 1

POINT 2

POINT 3

VISIBLE

GRADS FORMAT

CALIBR

SCALES Menu, FORMAT Submenu, SPLIT

OFF

Parameter

Choices

Description

Table 3-4. SCALES Menu, FORMAT Submenu Parameters, SPLIT

OFF (Continued)

Advertising