Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 98)

94 820i Installation Manual
10.5 Custom Stream Formatting
Each port can be independently configured to stream a default frame format or can be customized to stream a
user-defined format. Custom formatting is very similar to the standard print formatting described in Section 6.0.
Table 10-7 on page 94 lists the format identifiers used to configure a custom stream format.
Format Identifier Defined By Description
<P[G | N | T]> STR.POS#n
STR.NEG#n Polarity. Specifies positive or negative polarity for the current or
specified (Gross/Net/Tare) weight on the source scale. Possible
values are SPACE, NONE, + (for STR.POS#n), or – (for STR.NEG#n)
<U[P | S | T]> STR.PRI#n
STR.SEC#n
STR.TER#n Units. Specifies primary, secondary, or tertiary units for the current or
specified weight on the source scale.
<M[G | N | T]> STR.GROSS#n
STR.NET#n
STR.TARE#n Mode. Specifies gross, net, or tare weight for the current or
specified weight on the source scale.
<S> STR.MOTION#n
STR.RANGE#n
STR.OK#n
STR.INVALID#n Status for the source scale. Default values and meanings for each
status:
STR.MOTION#n
M In motion
STR.RANGE#n O Out of range
STR.OK#n <space> OK
STR.INVALID#n I Invalid
<B [–]n,…> See descriptions below Bit fields. Comma-separated sequence of bit field specifiers. Must
be exactly 8 bits. Minus sign ([–]) inverts the bit.
B0 — Always 0
B1 — Always 1
B2 Configuration =1 if even parity
B3 Dynamic =1 if MODE=NET
B4 Dynamic =1 if COZ
B5 Dynamic =1 if standstill
B6 Dynamic =1 if gross negative
B7 Dynamic =1 if out of range
B8 Dynamic =1 if secondary/tertiary
B9 Dynamic =1 if tare in system
B10 Dynamic =1 if tare is keyed
B11 Dynamic =00 if MODE=GROSS
=01 if MODE=NET
=10 if MODE=TARE
=11 (not used)
B12 Dynamic =00 if UNITS=PRIMARY
=01 if UNITS=SECONDARY
=10 if UNITS=TERTIARY
=11 (not used)
B13 Configuration =00 (not used)
=01 if current DSPDIV=1
=10 if current DSPDIV=2
=11 if current DSPDIV=5
B14 Configuration =00 (not used)
=01 if primary DSPDIV=1
=10 if primary DSPDIV=2
=11 if primary DSPDIV=5
B15 Configuration =00 (not used)
=01 if secondary DSPDIV=1
=10 if secondary DSPDIV=2
=11 if secondary DSPDIV=5
B16 Configuration =00 (not used)
=01 if tertiary DSPDIV=1
=10 if tertiary DSPDIV=2
=11 if tertiary DSPDIV=5
Table 10-7. Custom Stream Format Identifiers