6 batching control commands, Batching control commands – Rice Lake 820i Programmable Indicator/Controller - Installation Manual User Manual
Page 92
88
820i
Installation Manual
9.1.6
Batching Control Commands
The commands listed in Table
9-12 provide batching control through the serial port
Table 9-12. Batching Control Commands
Command
Description
Values
BATSTART
Batch start
If the BATRUN digital input is active (low) or not assigned, the BATSTART
command can be used to start the batch program.
BATSTOP
Batch stop
Stops the batch program and turns off all associated digital outputs.
BATPAUSE
Batch pause
Stops the batch program at the current step. All digital outputs set on by the
current step (except for those set by concur setpoints) are set off. The
BATSTRT DIGIN, BATSTART serial command, Batch Start softkey, or the
StartBatch function in an
iRite-IDE
program can be used to restart the batch
program at the current step.
BATRESET
Batch reset
Stops the program and resets the batch program to the first batch step. Run
the BATRESET command after making changes to the batch configuration.