Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 38)

34 820i Installation Manual
HANDSHK OFF
XONOFF
HRDWAR Specifies whether XON/XOFF flow control characters or hardware handshaking is used.
Hardware handshaking is available only on Port 2.
PORTTYPE 232
485 Specifies whether Port 4 is used for RS-232 or RS-485 communications. If 485 is selected,
additional prompts are shown to specify half- or full-duplex operation and RS-485 address.
Note
RS-485 communications can be specified for Ports 4 and 7.
DUPLEX HALF
FULL Specifies whether the RS-485 communications is half- or full-duplex.
ADDRESS 0
0–255 Specifies the decimal indicator address for RS-485 connections. RS-232 communications is
disabled if an address other than zero is specified for this parameter. RS-485 addresses must
be in the range 01–255.
STREAM OFF
LFT
INDUST
4KEYS
KEYPAD
DISPLAY Specifies what data, if any, is streamed from the port.
4KEYS and KEYPAD stream keypad events to a receiving indicator. KEYPAD transmits all
keypad events; 4KEYS transmits keypresses of the ZERO, GROSS/NET, TARE, and UNITS
keys only.
DISPLAY streams the complete display image to the receiving indicator in local/remote
indicator configurations. See Section
10.4 on page 93 for more information.
Note Streaming is not supported for RS-485 connections.
SOURCE source_scale If STREAM is set to a value other than OFF, SOURCE specifies the source scale for data
streamed from the port.
SFMT format Specifies the stream format used for the streamed data (SCALE or IND SC scale types). The
default format is the Consolidated Controls format (see Section
10.6 on page 96). See
Section 10.5 on page 94 for information about custom stream formatting.
TOKENS PRIMAR
SECNDR
TERTIA
GROSS
INVALID
MOTION
ZERO
NET
OK
RANGE
TARE If STREAM is set to OFF, the TOKENS parameter can be used to replace tokens used in the
data stream from the indicator front panel. See Section
10.5 on page 94 for more information
about custom stream formatting.
TESTCOM — iQUBE communications tests.
Level 4 Submenus iQUBE only
VALIDAT — Use Upload softkey to retrieve serial numbers of attached iQUBE units.
SERIAL Menu
Parameter Choices Description
Table 3-6. Serial Menu Parameters (Continued)