Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 43)

Configuration 39
FEATURE Menu, CONTACT Submenu
The CONTACT submenu allows entry of contact information for a contact company or scale dealer. Contact
information can be displayed by pressing the
Contacts
softkey on the Version menu in setup mode or the
Diagnostics
softkey when in weigh mode. Contact information may be used in print formats (see Section 6.0 on
page 54).
address_line_1 address_line_2 contact_name_1
SCALES SERIAL FEATURE PFORMT SETPTS DIG I/O ALGOUT VERS
CONTACT
CMPNY ADDR1 ADDR2 NAME1 NAME2
PHONE1 PHONE2 EMAIL
phone_number phone_number email_address
contact_name_2 company_nam e
NEXTCAL
date
DISPLAY
Figure 3-12. CONTACT Submenu
Table 3-8. CONTACT Submenu Parameters
FEATURE Menu, CONTACT Submenu
Parameter Choices Description
Level 3, CONTACT submenu
CMPNY company_name Enter the name of the contact company or dealer.
ADDR1–ADDR2 address Enter up to three lines of address information for the contact company.
NAME1–NAME2 contact_name Enter names of up to three contact persons.
PHONE1–PHONE2 phone_number Enter phone numbers for each of the contact persons specified for the NAMEx
parameter.
EMAIL email_address Enter the e-mail address of the contact company or dealer.
If the iQUBE alert support is used to send automated alert e-mail messages,
enter the e-mail address to which the alert messages will be sent. See the iQUBE
Installation Manual, PN 77224 for more information about iQUBE alerts.
NEXTCAL* date Enter the next scheduled calibration date using the month/day/year format on the
DATEFMT parameter. Separator characters are not required.
*If value is not changed, date will reflect 6 months out from last calibration.