Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 5)

1
About This Manual
This manual is intended for use by service technicians
responsible for installing and servicing
820i ® digital
weight indicators. This manual applies to Version 1.04
of the
820i indicator software.
Configuration and calibration of the indicator can be
accomplished using the
Revolution ® configuration
utility, serial commands, or the indicator front panel
keys. See Section 3.1 on page 15 for information
about configuration methods.
This manual can be viewed and downloaded
from the Rice Lake Weighing Systems
distributor site at
www.ricelake.com .
The Operator Card included with this manual
provides basic operating instructions for users of the
820i . Please leave the Operator Card with the
indicator when installation and configuration are
complete.
Safety Section
Safety Symbol Definitions:
Indicates a potentially hazardous situation that, if not avoided may result in minor or moderate injury.
Indicates a potentially hazardous situation that, if not avoided could result in death or serious injury,
and includes hazards that are exposed when guards are removed.
Indicates information about procedures that, if not observed, could result in damage to equipment or
corruption to and loss of data.
Safety Precautions
Do not operate or work on this equipment unless you have read and understand the instructions and
warnings in the Installation, Operation and Maintenance Manual. Failure to follow the instructions or
heed the warnings could result in injury or death. Contact any Rice Lake Weighing System dealer for
replacement manuals. Proper care is your responsibility.
Some procedures described in this manual require work inside the indicator enclosure. These
procedures are to be performed by qualified service personnel only.
General Safety
Failure to heed may result in serious injury of death.
DO NOT allow minors (children) or inexperienced persons to operate this unit.
DO NOT operate without all shields and guards in place.
DO NOT step on the unit.
DO NOT jump up and down on the scale.
DO NOT use for purposes other then weight taking.
DO NOT place fingers into slots or possible pinch points.
DO NOT use any load bearing component that is worn beyond 5% of the original dimension.
DO NOT use this product if any of the components are cracked.
DO NOT exceed the rated load limit of the unit.
DO NOT make alterations or modifications to the unit.
DO NOT remove or obscure warning labels.
DO NOT use near water.
Before opening the unit, ensure the power cord is disconnected from the outlet.
Keep hands, feet and loose clothing away from moving parts.
Caution
WARNING
Important
Warning
WARNING