Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 89)

Serial Commands 85
SP.BRANCH#n Branch destination 0, 1-100
SP.RELNUM#n Relative setpoint number 1–100
SP.START#n Starting setpoint 1–100
SP.END#n Ending setpoint 1–100
SP.DISLOT#n Digital input slot NONE, SLOTx
SP.MASK#n Digital input mask number
SP.NSAMPLE#n Number of samples number
SP.TIME#n Trip time hhmm
SP.DURATION#n Trip duration hhmmss
SP.VUNDER#n Underrange value number
SP.VOVER#n Overrange value number
SP.DUNDER#n Underrange digital output BITx
SP.DACCEPT#n Accept digital output BITx
SP.DOVER#n Overrange digital output BITx
BATCHNG Batching mode OFF, AUTO, MANUAL
SP.ENABLE#n Setpoint enable ON, OFF
For setpoint commands ending with “#n”, n is the setpoint number.
Table 9-7. PFORMT Serial Commands
Command Description Values
GFMT.FMT
GFMT.PORT Gross demand print format string For .PORT commands, specify the port number as PORTxx (no
leading zero). For example: GFMT.PORT=PORT3.
For AUXFMT.FMT commands, specify the auxiliary format number
(1—20) as AUXFMTxx (no leading zero). For example:
AUX8FMT=GROSS<G><NL2>…
See Section 6.0 on page 54 for information about demand print
format strings.
See the iQUBE Installation Manual, PN 77224, for more information
about alert formats.
NFMT.FMT
NFMT.PORT Net demand print format string
ACC.FMT
ACC.PORT Accumulator print format string
SPFMT.FMT
SPFMT.PORT Setpoint print format string
TRWIN.FMT
TRWIN.PORT Truck weigh-in print format string
TRWOUT.FMT
TRWOUT.PORT Truck weigh-out print format string
TR.FMT
TR.PORT Truck register print format string
ALERT.FMT
ALERT.PORT Alert format string
HDRFMT1
HDRFMT2 Ticket header format strings
AUXFMTxx.FMT
AUXFMTxx.PORT Auxiliary ticket format
AUD.PORT Audit trail port
WDGT#1=n,f,d,s Widget display Sets scale display characteristics, where: n = widget number; f = font;
d = number of scale displays; s = screen number.
The 820i supports the following widget display configurations:
WDGT#1=1,3,1,1 Single scale display, larger font
WDGT#1=1,2,2,1 Dual scale display, smaller font
Command Description Values
Table 9-6. SETPNTS Serial Commands (Continued)