Rice Lake CLS-920i Cargo Lift Scale Installation Manual - Manual (Page 12)

8 CLS-920i Installation Manual
2.0 Scale Base Installation
This section describes procedures for installing the CLS-920i scale base.
WARNING
Take all necessary safety precautions when installing the scale carriage. including wearing safety shoes,
protective eyewear and using the proper tools which are listed in Section 2-3.
The CLS-920i Cargo Lift Scale is shipped from the factory with the scale already calibrated to the indicator.
Minimal recalibration and adjustments might be necessary once the scale is installed onto the forklift. Those
calibration steps are contained in Section 6.0.
2.1 Unpacking
The CLS-920i Cargo Lift Scale is shipped upright on a sealed pallet as shown in Figure 2-1.
Component
parts inside of
box
Figure 2-1. CLS-920i Packaging
Upon receipt of the shipping pallet, inspect it for any visible signs of damage. Immediately after unpacking,
visually inspect the contents to ensure all components are included and undamaged. The shipping pallet should
contain the following:
• One (1) scale carriage assembly with cover plate
• Indicator component box which includes the following:
- One (1) electronic indicator with mounting bracket and hardware
- One (1) power cable
- CLS-920i Cargo Lift Installation manual
• Hardware component box which includes the following:
- Two (2) cleats with four bolts
- Cage clamp mounting assembly and hardware
- Two (2) lithium-ion batteries (wireless version)
- Two-bay battery charger (wireless version)
- Coiled interface cable (wired version)
Note
To ensure that all products received from the manufacturer are in good shape upon arrival, it is recommended
to fully inspect all contents and properly fill out the bill of lading.
If any parts were damaged in shipment, notify Rice Lake Weighing Systems and the shipper immediately.