Rice Lake CLS-920i Cargo Lift Scale Installation Manual - Manual (Page 36)

8;&30 87"- 841"/ 8-*/ 3&;&30
10*/5
 10*/5
 10*/5
 10*/5
 10*/5

7*4*#-& (3"%4 '03."5 $"-*#3
y y
32 CLS-920i Installation Manual
Figure 4-6. SCALES Menu, CALIBR Submenu
Table 4-4. SCALES Menu, CALIBR Submenu Parameters
SCALES Menu, CALIBR Submenu
Parameter Choices Description
Level 4, CALIBR submenu
WZERO — Press ENTER to display and edit the zero calibration A/D count or millivolts value.
WVAL — Press ENTER to display and edit the test weight value.
WSPAN — Press ENTER to display and edit the span calibration A/D count or millivolts value.
WLIN POINT 1 —
POINT 5 Press ENTER to display and edit test weight and calibration values for up to five linearization points.
Perform linear calibration only after WZERO and WSPAN have been set.
REZERO — Press ENTER to remove an offset value from the zero and span calibrations.
Note Use this parameter only after WZERO and WSPAN have been set.
Note
For the CLS Series Cargo Lift Scale, do not use this section as reference for calibration. Please refer to. Section
6.0 for complete calibration instructions.