Rice Lake CLS-920i Cargo Lift Scale Installation Manual - Manual (Page 51)

CLS-920i Installation Manual 47
4.2.7 Analog Output Menu
The ALGOUT menu is shown only if the analog output option is installed. If the analog output option is installed,
configure all other indicator functions and calibrate the indicator itself before configuring the analog output. See
the Analog Output Card Installation Instructions, PN 69089, for more information.
4$"-&4 4&3*"- '&"563& 1'03.5 4&5154 %*(
*0 "-(065 7&34
OVNCFS

OVNCFS
4063$&
130(
0''4&5


&33"$5
4$"-&
O
'6--4$
)0-%
;&304$
.*/
OVNCFS

."9
OVNCFS

58;&30

5841"/ .0%&
(3044
/&5
*G
4063$&ò
130(

Figure 4-16. Analog Output Menu
Table 4-10. Analog Output Menu Parameters
ALG OUT Menu
Parameter Choices Description
Level 2 submenus
SOURCE1 PROG
SCALEn Specifies the scale tracked by the analog output. PROG indicates that the analog output is under
program control.
MODE1 GROSS
NET Specifies the weight data, gross or net, tracked by the analog output.
OFFSET 0%
20% Zero offset. Select 0% for 0–10 V or 0–20 mA output; select 20% for 4–20 mA output. This
parameter must be set before calibrating the analog output.
ERRACT FULLSC
HOLD
ZEROSC Error action. Specifies how the analog output responds to system error conditions.
Possible values are:
FULLSC: Set to full value (10 V or 20 mA)
HOLD: Hold current value
ZEROSC: Set to zero value (0 V or 4 mA)
MIN 000000
0–9999999 Specifies the minimum weight value tracked by the analog output. Specify a value in the range
0–9999999.
MAX 10000
0–9999999 Specifies the maximum weight value tracked by the analog output. Specify a value in the range
0–9999999
TWZERO 40
0–65535 Tweak zero. Enter tweak value to adjust the analog output zero calibration. Use a multimeter to
monitor the analog output value.
TWSPAN 59650
0-65535 Tweak span. Enter tweak value to adjust the analog output span calibration. Use a multimeter to
monitor the analog output value.