Rice Lake CLS-920i Cargo Lift Scale Installation Manual - Manual (Page 5)

CLS-920i Installation Manual 1
About This Manual
This manual is intended for use by individuals responsible for installing the CLS-920i Cargo Lift Scale along with
the 920i HMI digital weight indicator. This manual covers information on the installation of the scale carriage,
signal cable installation (if applicable), and the installation, configuration, and calibration of the 920i HMI digital
weight indicator.
Note
While the functionality remains the same for the standard 920i HMI digital weight indicator, there are certain
menu choices found in the User Configuration section of this manual that are specific to this application.
The CLS-920i Operator Card, PN 96313 included with this manual, provides basic operating instructions for users
of the CLS-920i and the 920i HMI digital weight indicator. Please leave the operator card with the indicator when
installation and configuration is complete.
configuration is complete.
Safety
Safety Symbol Definitions:
Important
CAUTION
WARNING
DANGER Indicates an imminently hazardous situation that, if not avoided, will result in death or serious injury.
Indicates a potentially hazardous situation that, if not avoided could result in death or serious injury, and
includes hazards that are exposed when guards are removed.
Indicates a potentially hazardous situation that, if not avoided may result in minor or moderate injury.
Indicates information about procedures that, if not observed, could result in damage to equipment or
corruption to and loss of data.
General Safety
WARNING
Do not operate or work on this equipment unless you have read and understand the instructions and
warnings in the Installation, Operation and Service Manuals. Failure to follow the instructions or heed
the warnings could result in injury or death. Contact any Rice Lake Weighing System dealer for
replacement manuals. Proper care is your responsibility.
Failure to heed may result in serious injury of death.
Some procedures described in this manual require work inside the indicator enclosure. These procedures are to be
performed by qualified service personnel only.
Take all necessary safety precautions when installing the scale carriage including wearing safety shoes, protective eye
wear, and using the proper tools.
DO NOT allow minors (children) or inexperienced persons to operate this unit.
DO NOT operate without all shields and guards in place.
DO NOT jump up and down on the scale.
DO NOT use for purposes other then weight taking.
DO NOT place fingers into slots or possible pinch points.
DO NOT use any load bearing component that is worn beyond 5% of the original dimension.
DO NOT use this product if any of the components are cracked.
DO NOT exceed the rated load limit of the unit.
DO NOT make alterations or modifications to the unit.
DO NOT remove or obscure warning labels.
DO NOT use near water.
Keep hands, feet and loose clothing away from moving parts.