Acura 2008 TSX - Owner's Manual - Manual (Page 135)

To change the ‘‘INTERIOR LIGHT
DIMMING TIME,’’ see page
.
If you unlock the doors with the
remote transmitter, but do not open
any doors within 30 seconds, the
doors automatically relock and the
security system sets. To change this
setting, refer to ‘‘SECURITY
RELOCK TIMER’’ on page
.
Each remote transmitter also
activates the Driving Position
Memory System and changes the
‘‘MEMORY POSITION LINK’’
setting according to that remote (see
page
).
Press this button for
about 1 second to attract attention;
the horn will sound and the exterior
lights will flash for about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter, or turn the ignition
switch to the ON (II) position.
Press this button for
about 1 second to open the trunk.
You cannot open the trunk if the key
is in the ignition switch.
Standing outside the vehicle with
all the doors shut, push the lock
and unlock buttons at the same
time until the LED on the remote
transmitter blinks 2 times.
Open and shut the driver’s door.
Use the remote transmitter to lock
and unlock the driver’s door.
Verify that the remote transmitter
is in the linked mode. Turn the
ignition switch to the ON (II)
position. The MID display should
read ‘‘Welcome Driver 1’’ or
‘‘Welcome Driver 2’’, depending on
which remote you just linked (the
remote number is on the back of
the remote transmitter).
If the MID display only reads
‘‘Welcome Driver’’ once the ignition
switch is turned to the ON (II)
position, the link from the remote
transmitter to the vehicle has failed.
Repeat the procedure. If the link still
fails, see your dealer.
106
115
1.
2.
3.
4.
143
Recalling a Memorized Driving
Position
PANIC
TRUNK
Linking Your Remote
Transmitter
Remote Transmitter
132
DRIVER 1 REMOTE DRIVER 2 REMOTE
2008 TSX
Table Of Contents Main Menu