Acura 2008 TSX - Owner's Manual - Manual (Page 68)

This indicator has three functions:
It comes on as a reminder that you
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page
).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
You will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page
).
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. For more information, see
page
.
When you press the hazard warning
button, both turn signals blink. All
turn signals on the outside of the
vehicle should flash.
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. If this indicator comes on at
any other time, there is a problem in
the ABS. If this happens, take the
vehicle to your dealer to have it
checked. With this indicator on, your
vehicle still has normal braking
ability but no anti-lock function. You
will also see a ‘‘CHECK ABS
SYSTEM’’ message on the multi-
information display (see page
).
For more information, see page .
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages
and ).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
1.
2.
3.
83
82
268
268
304 306
261
Instrument Panel Indicators
Turn Signal and
Hazard Warning
Indicators VSA Activation Indicator Anti-lock Brake System
(ABS) Indicator
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
65 2008 TSX
Table Of Contents Main Menu