Acura 2008 TSX - Owner's Manual - Manual (Page 140)

In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat’s temperature
drops.
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
Follow these precautions whenever
you use the seat heaters:
If the engine is left idling for an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current from the
battery.
Both front seats are equipped with
seat heaters. The passenger seat is
only heated in the seat bottom
because of the side airbag cutoff
system. The ignition switch must be in the
ON (II) position to use them. Push
the front of the switch, HI, to rapidly
heat up the seat. After the seat
reaches a comfortable temperature,
select LO by pushing the back of the
switch. This will keep the seat warm.
Seat Heaters
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
137
SEAT HEATER SWITCHES
Passenger’s
Seat
Driver’s
Seat
HEATERS
2008 TSX
Table Of Contents Main Menu