Power windows – Acura 2008 TSX - Owner's Manual User Manual

Page 151

Advertising
background image

If the driver’s

window senses any obstacle while it
is closing automatically, it will
reverse direction, and then stop. To
close the window, remove the
obstacle, then use the window switch
again.

Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.

The power window system has a key-
off delay function. The windows will
still operate for up to 10 minutes
after you turn off the ignition switch.
Opening either front door cancels
the delay function. You must turn
the ignition switch to the ON (II)
position again before you can raise
or lower the windows.

If the power windows do not operate
properly after resetting, have your
vehicle checked by your dealer.

Pull and hold the driver’s window
switch to close the window
completely, then hold the switch
for about 2 seconds.

Start the engine. Push down and
hold the driver’s window switch
until the window is fully open.

If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window fuse is removed, the
AUTO function may be disabled. If
this happens, the power window
system will need to be reset after
reconnecting the battery or installing
the fuse.

1.

2.

AUTO REVERSE

Power Windows

148

2008 TSX

Table Of Contents

Main Menu

Advertising