Acura 2008 TSX - Owner's Manual - Manual (Page 287)

If you do not complete the reset
procedure within 30 seconds after
selecting the reset mode, the mode
will be canceled automatically.
If you have the required service
performed but do not reset the
display, or reset the display without
performing the service, the system
will not show the proper
maintenance intervals. This can lead
to serious mechanical problems
because you will no longer have an
accurate record of when
maintenance is needed.
To cancel resetting the oil life,
press the INFO button on the
steering wheel to select
‘‘CANCEL’’ on the display, and
press the SEL/RESET button. Immediately have the service
performed, and make sure to reset
the display as previously described.
If the indicated maintenance service
is not done and the remaining engine
oil life reaches 0 %, the multi-
information display will show the
message ‘‘SERVICE PAST DUE’’
and the maintenance item code(s).
This message is displayed when the
total mileage is less than 10 miles
(for U.S. models) or 10 km (for
Canadian models) after the engine
oil life became 0 %.
To cancel the message, press the
INFO button on the steering wheel.
To see the message again, wait for
an interval for more than 5 seconds,
and then press the INFO button.
Maintenance Minder
284 2008 TSX
Table Of Contents Main Menu