Acura 2008 TSX - Owner's Manual - Manual (Page 147)

The system will move the driver’s
seat to the memorized position. The
indicator in the selected memory
button will flash during movement.
When the adjustment is complete,
you will hear two beeps, and the
indicator will stay on.
You cannot select a memorized
position if the transmission is in
reverse. Shift to another gear,
then select a position.
If the parking brake is not set, you
must press and hold the memory
button until the adjustment is
complete.
Doing any of the following after
pressing the MEMO button will
cancel the storing procedure.
Not pressing a memory button
within 5 seconds.
Pressing the MEMO button again
within 5 seconds.
Readjusting the seat position.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
All stored driving positions will be
lost if your vehicle’s battery goes
dead or is disconnected.
Press the desired memory button
(1 or 2) until you hear a beep.
Make sure the parking brake is set
(M/T) or the shift lever is in Park
(A/T).
To select a memorized position, do
this:
1.
2.
Notes for vehicles with M/T
Driving Position Memory System
Selecting a Memorized Position
144
MEMORY BUTTONS
2008 TSX
Table Of Contents Main Menu