Acura 2008 TSX - Owner's Manual - Manual (Page 299)

Make sure the engine and radiator
are cool.
Remove the radiator cap by
pushing down and turning
counterclockwise.
Relieve any pressure in the cooling
system by turning the radiator cap
counterclockwise, without
pressing down.
The coolant level should be up to
the base of the filler neck. Add
coolant if it is low.
Pour the coolant slowly and
carefully so you do not spill any.
Clean up any spill immediately; it
could damage components in the
engine compartment.
Put the radiator cap back on, and
tighten it fully.
Pour coolant into the reserve tank.
Fill it to halfway between the MAX
and MIN marks. Put the cap back
on the reserve tank.
Do not add any rust inhibitors or
other additives to your vehicle’s
cooling system. They may not be
compatible with the coolant or
engine components.
Check the fluid level in the
windshield washer reservoir at least
monthly during normal use.
Check the reservoir’s fluid level by
removing the cap and looking at the
level gauge attached to the cap.
4.
1.
2.
3.
5.
6.
Engine Coolant, Windshield Washers
Windshield Washers
296
RADIATOR CAP
LEVEL GAUGE
2008 TSX
Table Of Contents Main Menu