6 pc and printer, Standard operations – ALTANA LCS III User Manual
Page 22
21
Standard Operations
•
If the instrument is not used during a longer period
(1–12 hours).
•
If the instrument will never be switched off.
1.
Press Lamp Control in the Instrument Setup.
2.
Select On to switch on the Lamp.
3.
Select Save: in order to define a time interval for the burning
time of the lamp.
4.
Press the field below Save to select the lamp burning time.
5.
Select the length of time the lamp will be switched on.
Note: After this period of time the lamp will automatical turn off, after
no measurement has been made.
Note: The lamp will be restarted automatically for measurements.
6.
Press OK to confirm.
5.2.6 PC and printer
The LCS III is provided with 2 USB interfaces, which are located on
the back of the instrument (see
). These
interfaces can be used for exporting data and graphics to a printer,
updating data and for data communication to a personal computer.
These interfaces can be used for the connection of a USB stick, an
external USB keyboard or a USB Barcode handset scanner.
Note: A USB hub may be used to connect several accessories at a time.
A USB memory stick is used to upgrade data, see
.
Important Note: A screened USB cable must not be longer than
3 m!
Table 3 USB connector
USB Interfaces
Description
USB (Type B)
This USB interface is only intended for the LCS III to PC connection (with installation of the Data
Trans Software).
USB (Type A)
This USB port can be used to connect a printer, a USB memory stick and keyboard.