Compatible Systems 5.4 - Manual (Page 23)

Chapter 1 - Installation and Overview 17
OSPF Neighbors
This menu item displays an abbreviated list of current neighbors an their state.
This is equivalent to the command line’s show ospf nbr command. (See the
ospf(show) section)
Buffer
This menu item displays detailed information on the current status of the
device’s memory allocation and is the equivalent of the command line’s show
os memory command. (See the os(show) section.)
Show Restart Info
This menu item displays detailed information about the status of the device
when the last restart event occurred, and is the equivalent of the command
line’s show os resevent command. (See the os(show) section.)
Device Log
This menu item displays the log buffer, and is the equivalent of the command
line’s show system log buffer command. (See the system(show) section.)
Command Line Interface
This menu item allows you to enter other show commands in the Command
Line entry box, as described below.
Reset Statistics
This menu item sends a command to the current device which causes it to
reset all of its statistic counters.
The Command Line Edit Box
The Command Line Edit Box
This box is both a pull-down list and an edit box which allows you to enter
command line show commands. Any Statistics menu item you use will be
added to this pull-down menu. To enter other show commands which are not
included in the Statistics menu, choose the Statistics menu’s Command Line
Interface option to enter the command in the edit box. Press the Return key to
send the command to the device.
v Note: Other types of commands (e.g., reset, add, etc.) are not fully
supported by CompatiView. Only show commands should be used.