Compatible Systems 5.4 - Manual (Page 257)

Chapter 14 - General 251
Secondary Server
This sets the IP address (e.g., 192.168.9.99) or fully qualified domain name
(e.g., monkeywrench.com) of the secondary LDAP server which contains the
configuration.
Secondary Password
This string is used to authenticate the device to the secondary LDAP server.
If this is not set, then the device will attempt an anonymous bid to the server.
The Secondary Password may be up to 32 characters long.
Base
This specifies the portion of the LDAP tree where the configuration is
located.
RDN
This string specifies the relative distinguished name used in the LDAP server
to identify the entry which contains the configuration.
Timeout
This value is the number of seconds the device will wait for a response from
the LDAP server.
Priority
This value specifies which configurations take precedence. When new
configurations are added, the device’s configuration is rebuilt to include the
one that was just added.
If a new configuration contains a section which contains a higher priority than
one already in place, The new configuration (or configuration portion) is
added above the one that is already there. This enables higher priority sections
to take precedence.