Toshiba TMP87CP24AF - Manual

TOSHIBA
TMP87CM24A/P24A
CMOS 8-Bit Microcontroller
TMP87CM24AF, TMP87CP24AF
The TMP87CM24A/P24A are the high speed and high performance 8-bit single chip microcomputers. These
MCU contain, large ROM, RAM, input/output ports, LCD driver, a 8-bit AD converter, four multi-function
timer/counters, two serial interfaces, and two clock generators on chip.
Product No. ROM RAM Package OTP MCU
TMP87CM24A 32 Kx8 bits
2Kx8bits P-LQFP100-1414-0.50C TMP87PP24A
TMP87CP24A 48 K X 8 bits
Features
♦8-bit single chip microcomputer TLCS-870 Series
♦ instruction execution time: 0.5 jjs (at 8 MHz), 122 jjs (at 32 kHz)
♦ 129 types and 412 basic instructions
• Multiplication and Division (8 bitsx 8 bits, 16 bits -r 8 bits): Execution time 3.5 / js (at 8 MHz)
• Bit manipulations (Set/Clear/Complement/Load/Store/Test/Exclusive OR)
• 16-bit data operations
• 1-byte jump/call (Short relative jumpA/ector call)
♦ l4 interruptsources(External: 5, Internal: 9)
• All sources have independent latches each,
and nested interrupt control is available
• 4 edge-selectable external interruptswith noise reject
• High-speed task switching by register bank changeover
♦ lO-input/output ports (Max 69 pins)
♦ two 16-bit timer^ounters
• Timer, Event counter. External trigger timer. Window, PPG output
Pulse width measurement modes
♦Two 8-bit timer/counters
• Timer, Eventcounter, Capture (Pulse width/duty measurement),
PWM output, PDO modes
♦Time Base Timer (Interrupt frequency: 1 Hz to 16384 kHz)
♦ Divider output function (frequency: 1 kHz to 8 kHz)
♦watchdog Timer
♦ two 8-bit Serial Interfaces
• Each 8 bytes transmit/receive data buffer
• Internal/external serial clock, and 4-/8-bit mode
000707EBP1
I For a discussion of how the reliability of microcontrollers can be predicted, please refer to Section 1.3 of the chapter entitled
Quality and Reliability Assurance / Handling Precautions.
• TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress.
It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in
making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA
products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set
forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set
forth in the "Handling Guide for Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc..
• The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer,
personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These
TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high
quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury
("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments,
transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of
safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer's
own risk.
• The products described in this document are subject to the foreign exchange and foreign trade laws.
• The information contained herein is presented only as a guide for the applications of our products. No responsibility
is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third
parties which may result from its use. No license is granted by implication or otherwise under any intellectual
property or other rights of TOSHIBA CORPORATION or others.
• The information contained herein is subject to change without notice.
3
-
24-1 2002
-
10-03