Toshiba LF494 - Manual (Page 74)

TOSHIBA
6 F 8 A 0 7 7 4
To chjinge the counting rate:
The following cxiimple shows how to change the counting rate from 0.t)l ni^ to 0,9 1.
Key operation Display example Description
SET
□ G1: COUNT RATE
1
.
00
E^
2
ra^
Press [SET] first 10 start the items selection sequence
and select Cl: COUNT RATE from among the
configuration items using [ ► ] and [
a ] keys, Then
press [SET] again to display the current counting rale
(l .i)nh-
2
m' = O.Ot m^).
►
□ G1: COUNT RATE
1
- OOE^Ziii'
Pressing [ ► ], the cursor appears. Then press [ ► ] as
many limes as necessary to move the cursor to of
measuring unit.
▲
□
Gl: COUNT RATE
1. OOE-Zl
9. OOE-ll
Select "1” as the measuring unit by pressing [ a j.
(Note)
T hen inovc the cursor to the desired digit by pressing
[ ► ] and change the value. In this example repeat this
process until the display shows ""9,OOE—IL''
SbT
□
Gl: COUNT RATE
9. DOE-11
Pressing [SET], the cursor disappears and the new
counting rate display flickers, Press [SETj again to
store the new counting rate.
SEl’
□
Gl: COUNT RATE
Pressing [SET], the system returns to the items
selection sequence.
Notet The mill changes as show'n below by pressing [
^
m3—►!----►ml---- ►(bbl)~+(gal) —
In case of the converter for special specil'ications (refer to 7.3.J? "Convener for
Special specifications”), “bbl” can be selected.
The unit in parentheses (bbl), (gal) is shown only when the meter size is selected in
inches.
-
73
-