Comtrol AT Commands - Manual (Page 114)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
Conexant 102184B
3-88
Table 3-6. Call Setup Result Codes
Code Definition
0 No previous call (modem log has been cleared since any previous calls)
1 No dial tone detected
2 Reorder signal detected, network busy
3 Busy signal detected
4 No recognized signal detected (e.g., no signal, or nothing recognizable)
5 Voice detected * if this is a voice modem (e.g., V.253) operating in voice mode (e.g.,
+FCLASS=8.0)
7 Data Answering signal detected (e.g., V.25 ANS, V.8 ANSam)
8 Data Calling signal detected (e.g., V.25 CT, V.8 CI)
9 Fax Answering signal detected (e.g., T.30 CED, DIS)
A Fax Calling signal detected (e.g., T.30 CNG)
B V.8bis signal detected
Table 3-7. Multimedia Modes
Code Definition
0 Data Only
1 Fax Only
2 Voice
9 Video-telephony, H.324
A Other V.80 call
Table 3-8. DTE-DCE modes
Code Definition
0 Async data
1 V.80 transparent synchronous mode
2 V.80 framed synchronous mode
Table 3-9. V.34 INFO bit report
Bits Source bits Definition
31-30 INFO0 bit 20; 0
20-29 INFOc bits 79-88
16-19 INFOc bits 26-29 or 35-38 or 44-
47 or 53-56- or 62-65 or 71-74 Pre-emphasis field, selected by the symbol rate
chosen
12-15 INFOa bits 26-29
10-11 MP bit 50; 0
0-9 INFOa bits 40-49