Comtrol AT Commands - Manual (Page 187)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
102184B Conexant 5-11
+VIT - Voice Inactivity Timer (DTE/Modem)
This command sets the modem’s initial value for the DTE/modem inactivity timer.
Syntax
+VIT=<timer>
Defined Values
<timer> Decimal number corresponding to the time in units of 1.0
second. A value of 0 disables the timer.
Reporting Current or Selected Values
Command: +VIT?
Response: <timer>
Example: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +VIT=?
Response: <timer> range
Example: 0-255
Result Codes
OK <timer> = 0-255.
ERROR Otherwise, or if not in Voice Mode.
+VLS - Analog Source/Destination Selection
This command causes the modem to select one or more source/destinations of the analog
data.
Syntax
+VLS=<label>
Defined Values
<label> Decimal number corresponding to the selected analog
source/destination hardware configuration (see Table 5-5).
Command: +VLS?
Response: <label>
Example: 0 For the default setting.