Comtrol AT Commands - Manual (Page 44)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
Conexant 102184B
3-18
V - Result Code Form
This command selects the sending of short-form or long-form result codes to the DTE.
The parameter, if valid, is written to S14 bit 3.
Syntax
V<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Enables short-form (terse) result codes. Line feed
is not issued before a short-form result code.
1 Enables long-form (verbose) result codes.
(Default.)
Result Codes
OK <value>= 0 or 1.
ERROR Otherwise.
W - Connect Message Control
This command, in conjunction with S95 bits 0, 2, 3, and 5 (bits 2, 3, and 5 can be written
directly by the host or by the +MR, +ER, and +DR commands, respectively), control the
format of CONNECT messages (see Section 3.4 and Table 3-16). The actual result code
messages reported reflect the W command setting and the S95 bit settings. (Also see
+MR, +ER, and +DR commands.)
The W parameter value, if valid, is written to S31 bits 2 and 3.
Syntax
W<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 Upon connection, the modem reports only the
DTE speed (e.g., CONNECT 19200).
Subsequent responses are disabled. (Default.)
1 Upon connection, the modem reports the
modulation, line speed, the error correction
protocol, and the DTE speed, respectively.
Subsequent responses are disabled.
2 Upon connection, the modem reports the DCE
speed (e.g., CONNECT 14400). Subsequent
responses are disabled.
Result Codes
OK <value> = 0, 1, or 2.
ERROR Otherwise.