Comtrol AT Commands - Manual (Page 97)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
102184B Conexant 3-71
\K - Break Control
Controls the response of the modem to a break received from the DTE or the remote
modem or the \B command. The parameter value, if valid, is written to S40 bits 3, 4, and
5.
Syntax
\K<value>
Defined Values
<value> Decimal number corresponding to the selected option.
The response is different in three separate states.
The first state is where the modem receives a break from the
DTE when the modem is operating in data transfer mode:
0 Enter on-line command mode, no break sent to
the remote modem.
1 Clear data buffers and send break to remote
modem.
2 Same as 0.
3 Send break to remote modem immediately.
4 Same as 0.
5 Send break to remote modem in sequence with
transmitted data. (Default.)
The second case is where the modem is in the on-line
command state (waiting for AT commands) during a data
connection, and the \B is received in order to send a break to
the remote modem:
0 Clear data buffers and send break to remote
modem.
1 Clear data buffers and send break to remote
modem. (Same as 0.)
2 Send break to remote modem immediately.
3 Send break to remote modem immediately.
(Same as 2.)
4 Send break to remote modem in sequence with
data.
5 Send break to remote modem in sequence with
data. (Same as 4.) (Default.)